S.E.R. FAQ
Home
Search
NotTaR of Television Sets : Testing of replacement HOTs             
 Copyright © 1994-2007, Samuel M. Goldwasser. All Rights Reserved. Reproduction of this document in whole or in part is permitted if both of the following conditions are satisfied: 1. This notice is included in its entirety at the beginning. 2. There is no charge except to cover the costs of copying. I may be contacted via the Sci.Electronics.Repair FAQ (www.repairfaq.org) Email Links Page.

     << Replacement power transis.. |  Index  | Removing and replacing th.. >>

Testing of replacement HOTs

The following is useful both to confirm that a substitute replacement HOT is suitable and that no other circuit problems are still present. However, single scan line anomalies (particularly when changing channels and/or where reception is poor with a TV or when switching scan rates and/or when no or incorrect sync is present with a monitor) resulting in excessive voltage across the HOT and instant failure are still possible and will not result in an HOT running excessively hot.

(From: Raymond Carlsen (rrcc@u.washington.edu).)

After installing a replacement HOT in a TV set or monitor, I like to check the temperature for awhile to make sure the substitute is a good match and that there are no other problems such as a weak H drive signal. The input current is just not a good enough indicator. I have been using a WCF (well calibrated finger) for years. For me, the rule of thumb, quite literally, is: if you can not hold your finger on it, it's running too hot, and will probably fail prematurely. Touching the case of the transistor or heat sink is tricky....

Metal case transistors will be connected to the collector and have a healthy pulse (>1,200 V peak!) and even with plastic case tab transistors, the tab will be at this potential. It is best to do this only after the power is off and the B+ has discharged. In addition, the HOT may be hot enough to burn you.

A better method is the use of an indoor/outdoor thermometer. I bought one recently from Radio Shack for about $15 (63-1009). It has a plastic 'probe' on the end of a 10' cable as the outdoor sensor. With a large alligator clip, I just clamp the sensor to the heat sink near the transistor and set up the digital display near the TV set to monitor the temperature. The last TV I used it on was a 27" Sanyo that had a shorted H. output and an open B+ resistor. Replacement parts brought the set back to life and the flyback pulse looked OK, but the transistor was getting hot within 5 minutes... up to 130 degrees before I shut it down and started looking for the cause. I found a 1 uF 160 volt cap in the driver circuit that was open. After replacing the cap, I fired up the set again and monitored the heat sink as before. This time, the temperature slowly rose to about 115 degrees and stayed there. I ran the set all day and noticed little variation in the measurement. Test equipment doesn't have to cost a fortune.


 <<Replacement power transis.. | ToC | Removing and replacing th..>>